Rear Caliper Holder to Axle Bolt - 1978-85

  Rear brake caliper holder to axle boltFIAT Spider 2000 and Pininfarina 1978-1985  

Brake Caliper Wedge Clip

Brake caliper wedge clip set FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   Sold as a set of 4 stainless steel clips which services one caliper

Brake Rotor Locating Stud

Brake rotor locating stud or pinFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 Replace the brake disc locating studs if rusty or worn 2 required per wheel

Brake Bleeder Screw

Brake caliper bleeder screwFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 Requires one per caliper

High Performance Brake Speedbleeder Screw

Speed brake bleeder screwFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 Patented bleeder screw with the built-in check valve Turns brake bleeding into an easy one person job Sold...

High Performance Brake Stainless Steel Speedbleeder Screw

High performance stainless steel speed brake bleeder screwFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 Patented bleeder screw with the built-in check valve Turns brake bleeding...

Brake Bleeder Dust Boot

Brake caliper bleeder screw dust boot or capFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 One required per caliper

Brake Caliper Wedge

Brake caliper wedgeFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   Each caliper requires two wedges   These should be replaced at the first signs of pitting or...

Brake Caliper Wedge Kit

Brake caliper wedge kit FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   This kit contains parts for two wheels (one axle)   Four caliper wedges Eight wedge clips Four...

Brake Caliper Holder Spring

Brake caliper holder spring or clipFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Snaps into caliper bracket and rests against caliper Need two per caliper

Front Left Brake Dust Shield - 1972-85

Left front brake rotor dust shieldFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1972-1985 Except for Pininfarina 1985.5

Front Right Brake Dust Shield - 1972-85

Right front brake rotor dust shieldFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1972-1985 Except for Pininfarina 1985.5

Rear Brake Forward Half Dust Shield - 1966-85

  Rear brake dust shield forward most portion - left or right FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   This part of the dust shield goes over the caliper

Left Rear Brake Dust Shield - 1979-85

Driver (left) rear brake dust shield rearward most portion FIAT 124 Spider 2000 and Pininfarina - 1979-1985   Also fits late 1978 Spiders with rear axle with a rear cover

Right Rear Brake Dust Shield - 1979-85

  Passenger (right) rear brake dust shield rearward most portion FIAT 124 Spider 2000 and Pininfarina - 1979-1985   Also fits late 1978 Spiders with rear axle with a rear cover   NOTE - MINOR SURFACE RUST NOS - New Old Stock

Brake Pad Spring Kit - 1968-79

Brake pad spring kitFIAT 124 Spider and Spider 2000 - 1966-1979FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1979 Although originally fitted to 1968-79 Spiders these springs can be used on all 124's One kit per axle

Brake Pad Spring Kit - 1980-on

Brake pad spring kitFIAT Spider 2000 and Pininfarina 1980-1985 (except 1985 1/2)FIAT and Bertone X1/9 - 1980-1988 Although originally fitted to 1980 and newer cars, these springs can also be used on earlier models One kit per axle

Brake Hose Washer

Brake hose copper washerFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 2 washers required for each front hose 1 required for each rear caliper hose

Left Brake Hose Lock Plate

Left or passenger side brake hose lock plateFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1979-1988  ***RIGHT or Passenger SIDE***   Secures hose to caliper Does Not fit 1985 1/2...

Right Brake Hose Lock Plate

Right or passenger side brake hose lock plateFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1979-1988  ***LEFT or DRIVERS SIDE***   Secures hose to caliper Does Not fit 1985 1/2...

Brake Hose Clip

Brake hose metal clipFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 This clip is located where the metal line and rubber brake hose meet

Left Front Metal Brake Line

Left front metal brake line FIAT 124 Spider, Spider 2000 and Pininfarina - late 1977 to 1985 Can be used on earlier Spiders and Sport Coupes to eliminate the Low Pressure Indicator Block Must add our part BR9-028 (reservoir cap with float) to...

Long Metal Brake Line

Long metal brake line FIAT 124 Spider, Spider 2000 and Pininfarina - 1967 to 1985 FIAT 124 Sport Coupe - 1967 to 1975 Routes from the master cylinder to the compensator Total length is approximately 146" (373cm)

Brake Line Nut

Metal brake line nut FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985    

Brake Line to Body Plastic Clip

Brake line to body plastic clip  FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 FIAT and Bertone X1/9 - 1974-1988   Holds metal brake line (approx 5mm) as it runs along the body  

Brake Line T Connector

Metal brake T connector or splitter block FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina  1978-1985   Can also be used on earlier models   Located on rear axle

Brake Hose Banjo Bolt

  Brake hose banjo boltFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Attaches front brake hoses to caliper (except Pininfarina 1985 1/2)

Brake Master Cylinder Spout - 1966-77

Brake master cylinder inlet spoutFIAT 124 Spider and Sport Coupe - 1966 to early 1977 For 4mm ID hose

Brake Master Cylinder Spout - 1977-85

Brake master cylinder inlet spoutFIAT 124 Spider, Spider 2000 and Pininfarina - mid 1977-1985 For 7mm ID hose

Brake Booster Check Valve - 1976-85

Brake booster plastic check valveFIAT 124 Spider, Spider 2000 and Pininfarina 1976-1985 Fitted to the booster using rubber grommet as original

Brake Booster Check Valve Grommet - 1976-85

Brake booster check valve rubber grommetFIAT 124 Spider, Spider 2000 and Pininfarina 1976-1985 Used to secure the check valve to the booster

Brake Booster Check Valve - 1966-75

Brake booster banjo check valveFIAT 124 Spider and Sport Coupe 1966-1975

Brake Fluid Low Pressure Indicator - 1968-76

Brake fluid low pressure indicator block FIAT 124 Spider and Sport Coupe 1966 to early 1976   Up to spares number 1448208 in mid-1976   Not for vehicles with higher spares numbers (late 1976 and 1977)

Brake Compensator or Regulator Boot

    Brake pressure regulator or compensator rubber bootFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985

Brake Compensator Linkage Kit - Save 10%

      Brake compensator or pressure regulator linkage and bushing kitFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Save over 10%

Brake Compensator Linkage Rod Bushing

    Brake compensator linkage rod bushingFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985 Located where the compensator linkage connects to the rear axle When servicing brake components, don't take short cuts. Renewing...

Brake Compensator Linkage Bushing at Body

Brake compensator or pressure regulator linkage bushing at bodyFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 1 required per car

Brake Compensator Bushing to Body Bracket

Brake compensator or pressure regulator bushing to body bracketFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975  

Brake Compensator Linkage

Brake compensator or pressure regulator linkage FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   Connects the rod to the rear axle   For the bushings in the ends, use our part BR0-479  

Compensator Bushing Rod Sleeve

Brake compensator or pressure regulator linkage rod bushing inner sleeve or dowelFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 2 required per car

Brake Compensator Linkage Rod Plate

Brake compensator or pressure regulator linkage rod plateFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985

Brake Compensator Linkage Rod Spacer

Brake compensator or pressure regulator linkage rod spacerFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975

Brake Compensator Linkage Rod

Brake compensator linkage rodFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Sometimes missing or damaged, the brake pressure regulator actuating rod is an often overlooked part of a full brake service OEM Original - NOS New Old...

Brake Booster Linkage at Pedal

Brake booster pivot linkage pin at pedalFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985

Clamp for Brake Fluid Hose

Clamp for brake fluid hoseFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   10.5-12.5mm range   Four required per car 

Hand Brake Cable Union

Parking or hand brake cable unionFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985

Hand Brake Lever Handle

Parking brake handle cover FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985