Auto Ricambi

Timing Pointer - OEM

OEM upper timing pointer assemblyFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975   Can be installed on all DOHC motors, but 1974 to early 1977 with high...

Alternator Belt - 1977-85

Premium Dayco alternator belt FIAT 124 Spider, Spider 2000, Pininfarina - mid 1977-1985   Alternator on the driver's side   This belt goes around the alternator, water pump and crank...

Alternator Belt - 1966-77

Premium Dayco alternator belt FIAT 124 Spider, Sport Coupe - 1966 to mid 1977   Alternator on the passenger side   This belt goes around the alternator, water pump and crank pulleys...

Lower and Middle Timing Cover Bushing

Timing belt cover lower and middle bushingFIAT 124 Spider and Sport Coupe - 1966-1978 Need 4 per cover  Note - 1974 to early 1977 U.S. models with cam box mounted air pump also used a...

Upper Timing Cover Bushing

Timing belt cover upper bushingFIAT 124 Spider and Sport Coupe - 1966-1978 Need 2 per cover Note - 1974 to early 1977 U.S. models with cam box mounted air pump only use one of these

Timing Belt Cover Middle Bolt - 1966-78

Timing belt cover middle bolt FIAT 124 Spider and Sport Coupe - 1966-1978   Screws into the cylinder head to hold the middle of the timing belt cover 60mm long

Timing Belt Cover Lower Bolt - 1966-78

Timing belt cover lower boltFIAT 124 Spider and Sport Coupe - 1966-1978   Screws into the engine block to hold the bottom of the timing belt cover 70mm long

Air Pump Drive Belt - 1974 to early 1977

Premium air pump cogged drive beltFIAT X1/9 - 1974 to early 1977 For vehicles with cam driven air (smog) pumps

Air Pump Drive Belt - 1974-77

Premium air pump cogged drive beltFIAT 124 Spider and Sport Coupe - 1974-1977 For vehicles with cam driven air (smog) pumps

Connecting Rod Bearing Set - 1438cc

Connecting rod bearing set FIAT 124 Spider and Sport Coupe - 1966-1971 (1438cc) Select desired size

Connecting Rod Bearing Set - 1608cc

Connecting rod bearing setFIAT 124 Spider and Sport Coupe - 1971-1972 (1608cc)   Select desired size

Connecting Rod Bearing Set - 1498cc

Connecting rod bearing set FIAT X1/9 and Bertone - 1979-1988 (1498cc) Select desired size

Connecting Rod Bearing Set - 1973-85

Connecting rod bearing set FIAT 124 Spider, Spider 2000 and Pininfarina - 1973-1985 (1592, 1756 and 1995cc) Select desired size Has both centered and offset oil holes

Performance Connecting Rod Bearings - 1976-85

Ultra high-performance Glyco connecting rod bearing setFIAT 124 Spider, Spider 2000 and Pininfarina - 1976-1985   These bearings feature no oil holes as they are not needed (They were eliminated...

Main Bearing Set - 1438, 1608 and 1290, 1498cc

Main bearing set FIAT 124 Spider - 1966-1973 (1438 and 1608cc)FIAT 124 Sport Coupe - 1967-1973 (1438 and 1608cc)FIAT and Bertone X1/9 - 1974-1988 (1290 and 1498cc)   Select desired size

Main Bearing Set - 1592, 1756 and 1995cc

Main bearing set FIAT 124 Spider, Spider 2000 and Pininfarina - 1973-1985 (1592, 1756 and 1995cc)FIAT 124 Sport Coupe - 1973-1975 Select desired size

High Performance Main Bearing Set - 1973-85

Ultra high performance Glyco main bearing set - Standard SizeFIAT 124 Spider, Spider 2000 and Pininfarina - 1973-1985 (1592, 1756 and 1995cc)FIAT 124 Sport Coupe - 1973-1975 (1592, 1756cc) Approved...

Thrust Washer Set - Early

Thrust washer pairFIAT 124 Spider - 1966-1973 (1438 and 1608cc)FIAT 124 Sport Coupe - 1967-1973 (1438 and 1608cc)FIAT and Bertone X1/9 - 1974-1988   Choose Standard or Oversized option

Thrust Washer Set - Late

Thrust washer pair FIAT 124 Spider, Spider 2000 and Pininfarina - 1973-1985 (1592, 1756 and 1995cc)FIAT 124 Sport Coupe - 1973-1975 (1592 and 1756cc)   Choose Standard or Oversized (0.1mm)...

Auxiliary Shaft Bearing Set

Auxiliary shaft bearing setFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 These high quality, Italian made bearing sets are pre-sized and do not require re-sizing or expensive...

Timing Belt Tensioner Bearing - 1290cc

Timing belt tensioner bearingFIAT X1/9 - 1974-1978 (1290cc)   The tensioner bearing should be replaced at the same time as the timing belt   Auto Ricambi tensioner bearings are imported...

Timing Belt Tensioner Bearing - 1498cc

Timing belt tensioner bearingFIAT and Bertone X1/9 - 1979-1988 (1498cc)   The tensioner bearing should be replaced at the same time as the timing belt.   Auto Ricambi tensioner bearings are...

Timing Belt Tensioner Bearing - 1966-71

Timing belt tensioner bearingFIAT 124 Spider - 1966-1971 (1438cc)FIAT 124 Sport Coupe - 1966-1971 (1438cc) The tensioner bearing should be replaced at the same time as the timing belt Auto Ricambi...

Timing Belt Tensioner Bearing - 1971-85

Timing belt tensioner bearingFIAT 124 Spider, Spider 2000 and Pininfarina - 1971-1985  (1592, 1608, 1756 and 1995cc)FIAT 124 Sport Coupe - 1971-1975  (1592, 1608 and 1756) The tensioner...

High Performance Timing Belt Tensioner Bearing - 1971-85

High Performance timing belt tensioner bearingFIAT 124 Spider, Spider 2000 and Pininfarina - 1971-1985 (1592, 1608, 1756 and 1995cc)FIAT 124 Sport Coupe - 1971-1975 (1592, 1608 and 1756cc) This...

Timing Belt Tensioner Pivot Bolt Kit

Timing belt tensioner pivot bolt kit FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   This kit includes the following parts: Two large washers that retain the bearing The...

Tensioner Bearing Holder

Tensioner bearing holder FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975    

Timing Belt Tensioner Spring

Timing belt tensioner spring FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975   Not a bad idea to replace this worn spring too  

Timing Belt Tensioner Spring Bolt

  Timing belt tensioner spring boltFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Located in the middle of the timing belt tensioner spring

Pilot Shaft Bearing - 1966-83

Pilot shaft bearingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966 through 09/1983 - with 5-speed transmissionFIAT 124 Sport Coupe - 1967-1975 Located in the rear of the crankshaft It is good...

Pilot Shaft Bearing - 1983-85

Pilot shaft bearing09/1983-1985 Pininfarina Spider with 5-speed transmission Located in the rear of the crankshaft - its a good idea to replace this 32mm OD bearing at the same time as the clutch

Forged Piston Set - 1756cc and 1995cc - High Performance

Forged high-performance piston set by Traum FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1974-1985 (1756 and 1995cc) 85mm bore 10:1 Compression ratio 37.7mm compression height (can be...

Forged Piston Set - 1608cc - High Performance

Forged high-performance piston set by Traum FIAT 124 Spider and Sport Coupe - 1971-1973 (1608cc)   80mm bore (oversize options available) Supplied with pins and clips Supplied with thin low...

Piston Set - 1608cc - 80.4 or 80.8mm

Piston set - 80.4mm and 80.6mm sizes availableFIAT 124 Spider and Spirt Coupe 1971-1972 (1608cc) Choose your piston size 4.50mm dome, 37.7mm compression height Approximately 9.8:1 compression...

Piston Set - 1438cc - 9.4:1 Compression Ratio

Piston set 80.0mm, 80.4mm, and 80.8mm sizesFIAT 124 Spider and Sport Coupe - 1966-1971 (1438cc) Available in 80.0mm, 80.4mm & 80.8mm oversize 4.50mm dome Approximately 9.4:1 compression...

Piston Pin Bushing - 1982-85

Piston pr wrist pin bushingFIAT Spider 2000 and Pininfarina 1982-1985 - after engine number 1515813 - (1995cc)

Piston Pin Bushing - 1971-82

Piston or wrist pin bushing FIAT 124 Spider, Sport Coupe and Spider 2000 Spider 1971-1982 - to engine number 1515812 - (1608, 1592, 1756, 1995cc)

Piston Pin

Piston or wrist pinFIAT 124 Spider, Spider 2000 and Pininfarina 1971-1985FIAT 124 Sport Coupe - 1971-1975FIAT and Bertone X1/9 - 1974-1988    

Piston Pin Clip

Piston or wrist pin clipFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1971-1985 Sold individually

Piston Ring Set - 1498cc

Premium piston ring setFIAT X1/9 and Bertone - 1979-1988 (1498cc)   Premium rings manufactured in the USA   Note: The oil rings are an improved design which does not require sizing or...

Piston Set - 1300cc and 1500cc

Premium piston setFIAT X1/9 and Bertone - 1974-1988   Stock type cast pistons Choose between 86.4 or 87mm diameters Standard size for 1300cc is 86.0mm, for 1500cc is 86.4mm Small valve cutouts...

Auto Ricambi Special Forged Connecting Rod Set - 1995cc

Set of 4 Auto Ricambi Special forged 4340 steel connecting rods FIAT Spider 2000 and Pininfarina - 1979-1985 (1995cc)   Forged 4340 steel for the highest strength and durability H-beam...

OEM Connecting Rod - 1979-85

Connecting rodFIAT Spider 2000 and Pininfarina - 1979-1985 (1995cc) OEM Original FIAT

Connecting Rod Nut - 1966-78

  Connecting rod nutFIAT 124 Spider and Sport Coupe 1966-1978 (1438, 1608, 1592, and 1756cc) *** NOTE *** Some manuals list the torque for the rod nuts incorrectly! The correct torque...

Connecting Rod Bolt - 1971-78

Connecting rod boltFIAT 124 Spider and Sport Coupe 1971-78 (1608, 1592, 1756cc) *** NOTE *** Some manuals list the torque for the rod bolts incorrectly! The correct torque setting is 38 Ft-lb.

Connecting Rod Bolt - 1979-85

  Connecting rod boltFIAT Spider 2000 and Pininfarina 1979-1985 (1995cc)

Connecting Rod Nut - 1979-85

  Connecting rod nutFIAT 124 Spider and Pininfarina 1979-1985 (1995cc)  

Crankshaft Timing Belt Gear - 14mm flange

Crankshaft timing belt gear with a 14mm flangeFIAT 124 Spider - 1966-1977, up to engine number 0430996FIAT 124 Sport Coupe - 1967-1975 Replace at any sign of wear Steel gear, as original

Crankshaft Timing Belt Gear - 3mm flange

Crankshaft timing belt gear with a 3mm flange FIAT 124 Spider, Spider 2000 and Pininfarina - 1977 (from engine # 0430996) to 1985 FIAT X1/9 - 1974-1978   Replace if you see any signs of...

Cam Gear (Pulley) - Exhaust or Auxiliary

Exhaust cam gear - Can be also used for the auxiliary shaftFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 This pulley has the flange on front to prevent belt travel OE FIAT...

OE Cam Gear (Pulley) - Intake

OE Intake cam timing gearFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 This pulley has the flange on rear to prevent belt travel Original FIAT pulley - New Old Stock May have...

Cam Gear (Pulley) - Intake - FI - No flange

No flange intake cam gearFIAT 124 Spider 2000 and Pininfarina 1980-1985 with Fuel injection This item is needed for the 25mm wide performance timing belts BT5-439-Z