Auto Ricambi

Door Glass Vertical Channel Felt - Sport Coupe

Door glass vertical channel felt "U" moldingFIAT 124 Sport Coupe - 1966-1975   One piece is long enough to replace both the front and rear felt in both doors

Rubber “A” Pillar Plug

Rubber A pillar capFIAT 124 Spider - 1966-1978 Located at the front upper door opening, plugs the end of the door weatherstripping

Door Glass Channel Rubber Plug

Door glass channel upper rubber plugFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Located in upper rear corner of the vent window frame

Rubber "B" Pillar Vertical Top Frame Molding

      Rubber B pillar moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985  Located at the leading edge of the rear quarter window, seals against the door...

Rubber "B" Pillar Molding Brace

      Inner U-brace for the rubber B pillar molding (RE2-448)FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985  This metal brace is located inside the rubber B-pillar...

Rubber B-Pillar Caps - 1966-78

Rubber "B" pillar boot setFIAT 124 Spider - 1966-1978 One left and one right B pillar cap Located at the rear upper door opening Later versions see RE2-445

Rubber B-Pillar Caps - 1979-85

  Rubber "B" pillar boot or cap setFIAT Spider 2000 and Pininfarina - 1979-1985 One left and one right B pillar cap Located at the rear upper door opening For the earlier version see...

Left Front Door Corner Rubber Molding

Left front door corner rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Located behind stainless steel door corner trim

Left Rear Rubber Door Corner Molding

Left rear door corner rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Located behind stainless steel door corner trim 

Right Front Rubber Door Corner Molding

Right front door corner rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Located behind stainless steel door corner trim

Right Rear Rubber Door Corner Molding

Right rear door corner rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Located behind stainless steel door corner trim

Pininfarina Vent Window Seal - 1983-85

Triangle door window seal (left or right)Pininfarina Spider - 1983-1985 Fits either side Sold individually  

Spider Vent Window Seals - 1966-82

Vent or wing window seal pair (left and right)FIAT 124 Spider and Spider 2000 - 1966-1982 Note: This item can be difficult to install, a lot of patience and some trimming may be necessary

Sport Coupe Vent Seal Set - 1967-69

Vent or wing window seal pair (left and right) FIAT 124 Sport Coupe A-Series - 1967-1969   Note: This item can be difficult to install   An exact replica made in Italy by the...

Sport Coupe Vent Window Lower Pivot

Improved design, vent window lower pivot (left or right) FIAT 124 Sport Coupe - 1970-1975   This is a double sided pivot that holds the glass much better than the single sided glued stock...

Sport Coupe Vent Window Upper Pivot

Improved design, vent window upper pivot (left or right) FIAT 124 Sport Coupe - 1970-1975   This is a double-sided pivot that holds the glass much better than the single-sided glued stock...

A-Pillar Seals Pair - 1966-79

Rubber "A" pillar seal pair (driver and passenger side)FIAT 124 Spider and Spider 2000 - 1966-1979 Mounts on the windshield frame    

A-Pillar Seal - PAIR - 1980-85

Rubber "A" pillar sealsFIAT Spider 2000 and Pininfarina - 1980-1985 Mounts on the windshield frame PAIR, left and right side Perfectly molded as original Can also be used on earlier Spiders

A-Pillar Metal Molding - Driver Side

Metal "A" pillar molding driver (left) sideFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Mounts on windshield frame and holds the door weatherstripping and also the A-pillar...

A-Pillar Metal Molding - Passenger Side

Metal "A" pillar molding passenger (right) sideFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Mounts on windshield frame and holds the door weatherstripping and also the A-pillar...

Rear Quarter Window Seals - Spider

Rubber seals for top frame rear (triangular) windowFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985   Located at the trailing and lower edges of the rear 1/4 window (sold as a set for...

Rear Vent Window Seals - Sport Coupe 1967-72

Rubber seals for rear quarter vent windowsFIAT 124 Sport Coupe - 1967-1972   Sold as a set for both sides   Molded with the correct contour   Made in Italy using the original OEM...

Rear Vent Seal - Sport Coupe 1973-75

Rubber seals for rear quarter vent windowsFIAT 124 Sport Coupe - 1973-1975   Sold as a set for both sides Molded with the correct contour Made in Italy using the original OEM...

Rubber Wiper Cowl Drains

    Rubber wiper cowl drain pairFIAT 124 Spider and Sport Coupe - 1966 to mid-1978 The exact reproduction of the original parts that drain water from the cowl to the engine side of the...

Windshield Surround Gasket - OEM

OEM windshield surround rubber molding gasketFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Improved later design as found on Pininfarina Spiders  OEM original manufacturer - be...

Heater Tube Body Pass Through Gasket - OE with Metal Insert

      Heater tube pass through gasket with metal insert molded inside just like originalFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Located on the firewall...

Heater Tube Body Pass Through Gasket

Heater tube pass through gasketFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 Located on the firewall where the heater tubes pass into the engine compartment A faithfully...

Spider Trunk Rubber Molding

Trunk rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985   Rubber molding for the trunk compartment   Vulcanized components, directly imported from the manufacturers in...

Lower Rear Trunk Rubber Molding - Sport Coupe

Lower rear trunk rubber moldingFIAT 124 Sport Coupe - 1967-73 Rubber molding which fits into the rear lower trunk compartment seal holder Vulcanized components, directly imported from the...

Trunk Rubber Molding Pad - 1978-85

Trunk rubber molding padFIAT 124 Spider, Spider 2000 and Pininfarina - 1978-1985 These rare Auto Ricambi Exclusive OEM item are located at either side of the trunk rubber base They keep the trunk lid...

Trunk Prop Rubber End

Trunk prop rubber endFIAT 124 Spider - 1966-1978

Fuel Filler Door Rubber Pad

Fuel filler door rubber padFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Prevents the fuel filler lid from banging against the body of your FIAT Spider

Fuel Filler Neck Grommet

Fuel filler neck rubber grommetFIAT and Bertone X1/9 - 1974-1988FIAT 124 Rally CSA (FIAT 124 Abarth) Seals the fuel filler pipe as it enters the body

Steering Column Gasket at Firewall - 1966-72

      Steering shaft gasket at the firewallFIAT 124 Spider - 1966-1972

Steering Column Gasket at Firewall - 1972-85

Steering shaft gasket at firewallFIAT 124 Spider, Spider 2000 and Pininfarina - 1972-1985 FIAT 124 Sport Coupe - 1972-19751972 models please double check the style, it may use RE2-485  

Grille Surround Trim Gasket - 1966-85

Grille surround trim gasketFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 Trim to fit  Approximately 59" (150cm) long Goes around the entire grille trim

Radiator Opening Vertical Rubber - 1966-85

Engine compartment front vertical rubber FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985   Located on either side of lower radiator support   Sold as a pair  

Engine Compartment Front Rubber - 1966-82

    Engine compartment front rubber moldingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1982 Located just in front of the radiator on top of the core support

Engine Compartment Rubber - 1985

Engine compartment side rubber molding FIAT 124 Pininfarina - 1985 Fits along the fenders and rear of the engine compartment where the hood meets the body along fender One continuous...

Engine Compartment Side Rubber - 1966-84

Engine compartment side rubber molding FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1984   Fits along the fender where the hood meets the body   Left or right, sold individually

Hood to Cowl End Pad

Rubber to cowl hood end pad FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985   Replace your worn pads with new hood end rubber pads   These will keep the hood corners from...

Engine Compartment Rear Seal - 1966-78

Hood to cowl sealFIAT 124 Spider - 1966-1978 Slides into the existing plastic channel, slightly thicker than original  

Cowl to Body Seal - 1966-78

Wiper cowl to body seal FIAT 124 Spider - 1966-1978   Fits under the front and side edges of the cowl  

Engine Compartment Rear Seal - 1979-85

Hood to cowl sealFIAT Spider 2000 and Pininfarina - 1979-1984 Also fits some early 1985 models without rack and pinion steering and can be used on earlier Spiders Pinches between the front of...

Hood Insulation Pad Pair - 1966-78

Hood insulation liner pad FIAT 124 Spider - 1966-1978   A pair (left and right) of black perforated vinyl with 1/2" (12mm) foam padding   Some Spiders had space between the hood and...

Sport Coupe Hood Insulation Pad - 1970-72

Hood insulation liner pad FIAT 124 Sport Coupe - 1970-1972   Black perforated vinyl with 1/2" (12mm) foam padding Does not have the holes for clips, those have to be punched  

OEM Hood Insulation Pad Pair - 1966-78

OEM Hood insulation liner pad set FIAT 124 Spider - 1966-1978   A pair (left and right) of black perforated vinyl with OE style batting   Some Spiders had space between the hood and...

OEM Hood Insulation Pad - 1979-85

OEM Hood insulation pad or linerFIAT Spider 2000, Pininfarina - 1979-1985   A new 100% original production of hood pad found on your Spider   For required retaining clips see...

Hood Insulation Pad Clip - 1979-85

Hood insulation pad or liner clipFIAT Spider 2000, Pininfarina - 1979-1985   Used to secure the under hood insulation liner on your Spider 21 clips required per car

Hood Insulation Pad Clip - Coupe

Hood insulation pad or liner clipFIAT 124 Sport Coupe - 1967-1975   Used to secure the under-hood insulation liner on your Sport Coupe 21 clips required per car

Rubber Door Weatherstrip - Sport Coupe

  Door opening rubber weatherstrip kitFIAT 124 Sport Coupe - 1966-1975 One set does both left and right door opening Imported directly from the manufacturers in Europe for an exact...

Hood to Cowl Seal - Sport Coupe

Engine compartment rear seal at cowl - replaces two piece seal FIAT 124 Sport Coupe - 1967-1975   Cowl to hood   Single piece replacement for the original two piece unit   For the...