Auto Ricambi

CV Joint Boot - 1979-88

Constant velocity replacement bootFIAT and Bertone X1/9 - 1979-1988Lancia Beta Montecarlo and Scorpion - 1976-1977

Drive Shaft Rear Yoke - 1968-81

Drive shaft rear yokeFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1968 to April 1981 Located at the rear of the drive shaft.

Stub Axle - 1979-88

Rear stub axleFIAT and Bertone X1/9 - 1979-1988

Drive Shaft Protection Bracket

Drive shaft center protection or safety bracket FIAT 124 Spider - 1968-1971 FIAT 124 Sport Coupe - 1968-73   NOTE - can also be used on later model 124's

Driveshaft Center Support Kit

Driveshaft center support bracket rubber grommet & sleeve kitFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985 Fits where the center support bracket (cross member) bolts to...

Driveshaft Center Support Grommet

Driveshaft center support rubber grommet FIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   Installs in either end of the driveshaft center support crossmember, where...

Clutch Master Cylinder

Clutch master cylinderFIAT and Bertone X1/9 - 1974-1988Lancia Scorpion / Beta Montecarlo  - 1976-1977  

Clutch Slave Cylinder

Clutch slave cylinderFIAT and Bertone X1/9 - 1974-1988  

Valeo Clutch Kit - 1975-78

OEM factory original Valeo clutch kit  FIAT  X1/9 - 1975-1978 (1290cc)   This clutch kit is manufactured by Valeo, your Fiat's OEM factory original supplier.  Not just like the...

Clutch Kit - 1966-71 - Original Equipment VALEO

OEM factory original Valeo clutch kit FIAT 124 Spider and Sport Coupe - 1966-1971 (1438cc only)   This clutch kit is manufactured by Valeo your Fiat's OEM factory original supplier and...

OEM Valeo Clutch Kit - 1979-88

OEM factory original Valeo clutch kit  FIAT and Bertone X1/9 - 1979-1988 (1498cc)   This clutch kit is manufactured by Valeo, your Fiat's OEM factory original supplier.  Not just like...

Clutch Release Bearing Clip

Clutch release bearing clipFIAT and Bertone X1/9 - 1974-1988   Two needed per car  

Clutch Release Fork

Clutch release forkFIAT and Bertone X1/9 - 1974-1988  

Clutch Hose

Clutch fluid hoseFIAT and Bertone X1/9 - 1974-1988 212mm long, as original on 1979-1988 X1/9s Can be used on earlier 1974-1978 models Requires two washers 9CL498    

Clutch Hose Washer

Clutch hose washerFIAT and Bertone X1/9 - 1974-1988   Need two per car

High Performance Racing Clutch Kit

High-performance racing clutch kit with puck-style discFIAT 124 Spider, Spider 2000 and Pininfarina - 1971-1985 (1608, 1592, 1756 and 1995cc)FIAT 124 Sport Coupe - 1971-1975 (1608, 1592 and...

High Performance Road Clutch Kit

High-performance road clutch kitFIAT 124 Spider, Spider 2000 and Pininfarina - 1971-1985 (1608, 1592, 1756 and 1995cc)FIAT 124 Sport Coupe - 1971-1975 (1608, 1592 and 1756) Original Valeo pressure...

Clutch Release Bearing

Clutch release bearingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975   All metal construction

Release Bearing - 1974-88

Clutch release bearingFIAT and Bertone X1/9 - 1974-1988 All metal construction

Clutch Alignment Tool - 124

Clutch alignment toolFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 Used to hold the disc centered on the flywheel during installaion of a new clucth

Clutch Pedal

Clutch pedalFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975  

Clutch and Brake Pedal Bushing

Clutch and or brake pedal bushingFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985   Requires 2 bushings per pedal   Sold individually

Clutch Pedal Helper Spring

Clutch pedal helper springFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975    

Brake Pedal Return Spring

Brake pedal return spring FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975

Clutch Cable Return Spring and Hook

Clutch cable return spring & hook (at transmission) FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975   This updated version combines the original...

Clutch Fork Lever

Clutch fork or release bearing actuating leverFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 Replace at any signs of wear  

Transmission Clutch Fork Boot

Transmission clutch fork bootFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina - 1966-1985 This boot is located on the side of the transmission where the clutch actuating lever passes into...

Clutch Cable Adjusting Nut

  Clutch cable adjusting nutFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1966-1985 This nut is located on the end of the clutch cable at the transmission

Clutch Fork Pivot Bolt

Clutch release bearing actuating fork pivot boltFIAT 124 Spider, Spider 2000 and Pininfarina 1966-1985FIAT 124 Sport Coupe - 1967-1975    

Bell Housing to Block Dowel

      Bell housing to block alignment dowel FIAT 124 Spider, Spider 2000 and Pininfarina 1966-1985 FIAT 124 Sport Coupe FIAT and Bertone X1/9 2 required per motor Sold each

Differential Third Member Assembly - 1969-78 (3.9:1 Ratio)

      Differential third member assembly or pumpkinFIAT 124 Spider and Sport Coupe 1969 to early 1978 Does not fit late 1978s with cover on the back of the differential 3.9:1...

Limited Slip Differential - 1966-78

Limited slip differentialFIAT 124 Spider and Sport Coupe - 1966-1978 1/2 Helical gear limited slip differential - Keeps one rear wheel from spinning by distributing some drive torque to both...

Differential Ring and Pinion - 1969-78 (4.3:1 Ratio)

Differential ring gear and pinionFIAT 124 Spider and Sport Coupe 1969 to early 1978 Original 4.3:1 gear ratio which came in Spiders from 1971 to 1978 For front-loading differentials only

Differential Ring and Pinion - 1969-78 (3.9:1 Ratio)

Differential ring gear and pinionFIAT 124 Spider and Sport Coupe 1969 to early 1978 3.9:1 ratio Lowers engine rpm by approximately 10% compared to the 4.3:1 gears that came in most Spiders, resulting...

Differential Ring and Pinion - 1969-78 (4.1:1 Ratio)

Differential ring gear and pinionFIAT 124 Spider and Sport Coupe 1969 to early 1978  4.1:1 (41/10) ratio Lowers engine rpm by approximately 5% compared to the 4.3:1 gears that came in most...

Differential Ring and Pinion - 1978 1/2-80 (3.9:1 Ratio)

Differential ring gear and pinionFIAT 124 Spider and Spider 2000 1978 1/2 to early 1980 (January 1978 to approximately August 1979 production date) with a 3.9:1 ratio Ring gear is 24.2mm thick...

Differential Ring and Pinion - 1980-82 (3.9:1 Ratio)

      Differential ring gear and pinionFIAT Spider 2000 1980-1982. September 1979 production date to Spares Number 1966226 (Spares number located at bottom of firewall VIN tag) 3.9:1...

Differential Ring and Pinion - 1982-85 (3.9:1 Ratio)

  Differential ring gear and pinionFIAT Spider 2000 and Pininfarina 1982-1985 From Spares Number 1966227 on (Spares number is located at the bottom of the firewall VIN tag) 3.9:1 ratio Ring gear...

Differential Ring and Pinion - Scratch -1982-85 (3.9:1 Ratio)

  Garage sale items are parts that we have limited and non-replenishable quantities, scratch items, or New Old Stock Items.  Items are new unless otherwise stated.  There are no...

Differential Ring and Pinion - Automatic

      Differential ring gear and pinionFIAT Spider 2000 August 1979 to Spares Number 1966226 - with automatic transmission 3.58:1 ratio Note: One tooth on the ring gear has a slight...

Differential Ring Gear Bolt - 1968-78

      Differential ring gear boltFIAT 124 Spider and Sport Coupe 1968-1978 1/2

Differential Pinion Crush Sleeve - 1966-82

Pinion crush sleeveFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1982 (To spares number 1966226)FIAT 124 Sport Coupe - 1967-1975

Differential Pinion Crush Sleeve - 1982-85

      Pinion crush sleeveFIAT Spider 2000 and Pininfarina - from Spares Number 1966227 in 1982 to 1985 Fits 124's with 26.2mm axles  

Differential Pinion Nut - 1969-78

  Pinion nutFIAT 124 Spider and Sport Coupe 1969 to early 1978 Nylock nut

Differential Pinion Nut - 1978-85

  Pinion nutFIAT 124 Spider, Spider 2000 and Pininfarina 1978-1985 Peen over style nut

Differential Front Flange 1969-78

Differential front flangeFIAT 124 Spider - 1969 to early 1978FIAT 124 Sport Coupe - 1969-1975 Fits front load differential - located in front of the front pinion bearing

Differential Front Flange 1978-85

Differential front flangeFIAT 124 Spider, Spider 2000 and Pininfarina late 1978-1985 For rear load differentials This yoke goes in front of the differential pinion bearing and connects to the...

Driveshaft Flange Nut - 1969-85

  Drive shaft rear flange lock nutFIAT 124 Spider, Sport Coupe, Spider 2000 and Pininfarina 1969-1985  Original size tall nylock nut for the drive shaft to rear end bolts Need 4 per car

Driveshaft Flange Nut & Bolt - 1969-74

Drive shaft rear flange bolt and lock nut FIAT 124 Spider, Sport Coupe - 1969-1974 Original size tall nylock nut & bolt for the drive shaft to rear end bolts Need to purchase 4 per car

Differential Pinion Oil Slinger Washer - 1969-78

Pinion oil slinger washerFIAT 124 Spider and Sport Coupe early 1969 1978 Fits front load differential - located in front of the front pinion bearing

Differential Rear Cover 1978-85

Differential rear coverFIAT Spider 2000 and Pininfarina 1978-1985

Rear Axle Shaft Bearing

Rear wheel or axle shaft bearingFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975 Don't forget to order the retainer BG1-486, as they are not reusable Save...