Transmission

GL-4 Transmission Gear Oil

Ligui-Moly GL4 transmission gear oilFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   Supplied in 1 liter containers - approximately 1.1 quarts FIAT 124 Spider need...

Millers GL-4 Transmission Gear Oil

GL-4 80w90 transmission gear oil - Millers Oils (Supersedes the original GL-1)FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   Supplied in 1 liter metal containers...

OEM Clutch Kit - 1974

Valeo clutch kit - 4 speed transmissionFIAT  X1/9 - 1974 (1290cc) to spares #2050998   This kit includes Pressure plate 180mm disc Release (throw-out) bearing NOTE - The is the tall or thick pressure plate used only on the early SOHC models...

LuK Clutch Kit - 1975-78

LuK clutch kit - 4 speed transmissionFIAT  X1/9 - 1975-1978 (1290cc) after to spares #2050999   This kit includes Pressure plate 180mm disc Release (throw-out) bearing NOTE - The is the short or thin pressure plate used only on the later...

OEM Clutch Kit - 1979-88

OEM factory original Valeo clutch kit  FIAT and Bertone X1/9 - 1979-1988 (1498cc)   This kit includes   Pressure plate 190mm disc Release (throw-out) bearing Alignment tool

Clutch Release Fork

Clutch release forkFIAT and Bertone X1/9 - 1974-1988  

Clutch Hose

Clutch fluid hoseFIAT and Bertone X1/9 - 1974-1988 212mm long, as original on 1979-1988 X1/9s Can be used on earlier 1974-1978 models Requires two washers 9CL498    

Clutch Hose Washer

Clutch hose washerFIAT and Bertone X1/9 - 1974-1988   Need two per car

Bell Housing to Block Dowel

Bell housing to block alignment dowelFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 2 required per motor Sold individually

Differential Carrier Bearing - 1979-88

Differential carrier bearing FIAT and Bertone X1/9 - 1979-1988 (5 Speed)Lancia Scorpion Montecarlo - 1976-1977 2 bearings required per car

Non Magnetic Oil Drain Plug

Non-magnetic oil drain plugFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 (Transmission only) Requires a 12mm allen wrench - our part number LU0-001 Also fits transmission and...

Magnetic Oil Drain Plug

Magnetic oil drain plugFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 (Transmission only) Requires a 17mm wrench Also fits transmissions and differentials Does not fit the new...

Speedometer Drive Seal

Speedometer drive sealFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 This seal is located in the speedometer drive where the cable attaches

Transmission Gasket Set - 1974-78

Transmission gasket set - 4-Speed FIAT X1/9 - 1974-1978   Fits four-speed transmissions Supplied with input shaft seal    

Transmission Gasket Set - 1974-88

Transmission gasket set FIAT and Bertone X1/9 - 1974-1988   Fits both four and five-speed transmissions Supplied with input shaft and shifter seals, but no axle shaft seals Manufactured in Italy to the highest standards by Athena,...

Transmission Gasket Set with Seals - 1979-88

Transmission gasket set with seals FIAT and Bertone X1/9 - 1979-1988   Supplied with all seals - unlike some others Manufactured in Italy to the highest standards by Athena, specifically for your Fiat

Lower Transaxle Mount

Lower transmission or transaxle mountFIAT X1/9 - 1975-1980   Intended for 1975-80 models but can be used on later X1/9s and Bertone - For later models there is no provision for attachement of the exhaust system

Shift Rod at Body Boot

Shifter rod to body bootFIAT and Bertone X1/9 - 1974-1988 Shift lever rod boot located where the rod enters the body.

Transmission Synchronizer Ring - 5th Gear

5th gear transmission synchronizer ring FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT X1/9 - 1974-1977 - 3rd and 4th gears only FIAT & Bertone X1/9 - 1979-1988    

FIAT 131/Brava Transmission Gasket Set

  Garage sale items are parts that we have limited and non-replenishable quantities, scratch items, or New Old Stock Items.  Items are new unless otherwise stated.  There are no returns on Garage Sale items.   FIAT 131 Transmission...

X 1/9 Reverse Light Switch

Reverse light switchFIAT and Bertone X1/9 - 1974-1988  

X1/9 Left Stub Axle Seal

Left side stub axle seal FIAT X1/9 and Bertone - 1979-1988     For five speed transmissions

X1/9 Right Stub Axle Seal

Right side stub axle seal FIAT X1/9 and Bertone - 1979-1988   For five speed transmissions

X1/9 Shifter Seal

Transmission shifter seal FIAT X1/9 and Bertone - 1974-1988   Located where the shift rod enters the transmission  

Shifter Flexible Linkage

Transmission shifter flexible linkage - sometimes call "lollypop" FIAT X1/9 and Bertone - 1974-1988 (except 1979-1980 carbureted)    

Input Shaft Seal

Input shaft seal FIAT X1/9 and Bertone - 1974-1988 Transmission input shaft seal      

Shift Linkage Bolt Nut & Bushing Kit

Transmission shifter linkage kit - bolt, nut and bushing FIAT X1/9 and Bertone - 1974-1988 FIAT 500 N/D/F/R, Giardiniera - 1957 -1975  

Cluster shaft - 1979-80

Cluster shaftFIAT X1/9 - 1979 to 11/1980 production date With keyed 5th gear - Toothcount: 12/17/22/47 (not counting the reverse gear) Be sure to check the toothcount against your shaft before ordering

Reverse Idler Gear -1974-84

Transmission reverse idler gear FIAT & Bertone X1/9 - 1974-1984 to VIN #149269 31 teeth 16mm Inside diameter

1/2 Shift Fork - 1978-88

1/2 Shift forkFIAT and Bertone X1/9 - 1978 to 1988  

1st Gear -1984-88

Transmission first gear Bertone X1/9 - From VIN 0145857 (1984) to 1988 45 teeth

1-2-Reverse Synchro Sleeve - 1974-77

1-2-Reverse synchro sleeve FIAT and Bertone X1/9 - 1974-1977 Synchronizer sleeve for first and second gear which also incorporates the reverse gear Please check thickness to ensure this is the correct part - This is approx 24mm thick

1-2 OEM Slider Hub - 1974-88

1-2 slider hubFIAT and Bertone X1/9 - 1974-1988 This is the part that the synchronizer sleeve for first and second gears rides on OEM - Original FIAT part  

1-2 Synchro Ring - 1974-88

1-2 synchro ringFIAT and Bertone X1/9 - 1974-1988 This is the synchronizer ring for first or second gear Need one synchro ring per gear

1-2-Reverse Synchro Sleeve - 1977-88

1-2-Reverse synchro sleeveFIAT and Bertone X1/9 - 1977-1988 This is the synchronizer sleeve for first and second gear which also incorporates the reverse gear Please check thickness to ensure this is the correct part - This is approx 26mm thick

3-4 OEM Slider Hub - 1978-88

3-4 slider hubFIAT and Bertone X1/9 - 1978-1988 This is the part that the synchronizer sleeve for third and forth gears slides on OEM - Original FIAT part  

2nd Gear - 1977-88

Transmission second gear FIAT and Bertone X1/9 - 1977-1988 38 teeth  

3rd Gear - 1978-80

Transmission 3rd gear FIAT and Bertone X1/9 - 1978-1980 32 teeth - Always check tooth count before ordering  

3rd Gear - 1981-84

Transmission third gear FIAT and Bertone X1/9 - from VIN 147744 (1981) to 1984 57 teeth - Always check toothcount before ordering  

3/4 Shift Fork - 1974-88

3/4 Shift forkFIAT and Bertone X1/9 - From VIN 78919 to 1988    

4th Gear -1981-84

Transmission 4th gear FIAT and Bertone X1/9 - 1981-1984 (to VIN 0147744) 61 teeth - Always check tooth count before ordering For five-speed transmissions

4th Gear Bushing - 1977-88

4th Gear BushingFIAT and Bertone X1/9 - 1977-1988  

4th Gear -1979-80

Transmission fourth gear FIAT X1/9 - 1979-1980 49 teeth - Always check toothcount before ordering For five-speed transmissions

4th Gear -1984-88

Transmission fourth gear Bertone X1/9 - From VIN 0147744 (1984) to 1988 49 teeth For five-speed transmissions

4th Gear -1974-78

Transmission fourth gear FIAT X1/9 - From VIN ending in 78918 in 1976 to 1978 47 teeth For four-speed transmissions

5th Gear on Input Shaft - 1980-84

Transmission 5th gear on input shaft - splinedFIAT and Bertone X1/9 - From November of 1980-1984 (to spares number 147744) 51 teeth - Always check tooth count before ordering Splined connection to shaft

5th Gear Shift Fork - 1979-88

5th Gear shift forkFIAT and Bertone X1/9 - 1979 to 1988  

Key for 5th Gear - 1979-80

Key for fifth gear FIAT X1/9 - 1979 to November 1980 production date Use with our sku 9TR615

5th Gear on Input Shaft - 1979-80

Transmission fifth gear on input shaft - keyed attachmentFIAT X1/9 - 1979 to November 1980 production date 51 teeth For the key, use our sku 9TR090

5th Gear on Input Shaft - 1984-88

Transmission fifth gear on input shaft - splinedBertone X1/9 - 1984-1988 (after spares number 147744) 51 teeth - Mates with 9TR613 Splined connection to shaft

5th Gear - 1984-88

Transmission fifth gear on output shaftBertone X1/9 - 1984-1988 (after spares number 147744) 44 teeth

Synchronizer Sleeve - 5th Gear

Synchronizer sleeve 5th gearFIAT 124 Spider, Spider 2000 and Pininfarina - 1968-1985FIAT 124 Sport Coupe 1968-1975FIAT and Bertone X1/9 - 1979-1988