Transmission

GL-1 Transmission Gear Oil

GL-1 transmission gear oil - Millers OilsFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988   Supplied in 1 liter metal containers - approximately 1.1 quarts FIAT...

Valeo Clutch Kit - 1975-78

OEM factory original Valeo clutch kit  FIAT  X1/9 - 1975-1978 (1290cc)   This clutch kit is manufactured by Valeo, your Fiat's OEM factory original supplier.  Not just like the original... this IS the original clutch your FIAT was...

OEM Valeo Clutch Kit - 1979-88

OEM factory original Valeo clutch kit  FIAT and Bertone X1/9 - 1979-1988 (1498cc)   This clutch kit is manufactured by Valeo, your Fiat's OEM factory original supplier.  Not just like the original... this IS the original clutch your FIAT...

Clutch Release Fork

Clutch release forkFIAT and Bertone X1/9 - 1974-1988  

Clutch Hose

Clutch fluid hoseFIAT and Bertone X1/9 - 1974-1988 212mm long, as original on 1979-1988 X1/9s Can be used on earlier 1974-1978 models Requires two washers 9CL498    

Clutch Hose Washer

Clutch hose washerFIAT and Bertone X1/9 - 1974-1988   Need two per car

Bell Housing to Block Dowel

      Bell housing to block alignment dowel FIAT 124 Spider, Spider 2000 and Pininfarina 1966-1985 FIAT 124 Sport Coupe FIAT and Bertone X1/9 2 required per motor Sold each

Differential Carrier Bearing - 1979-88

Differential carrier bearing FIAT and Bertone X1/9 - 1979-1988 (5 Speed)Lancia Scorpion Montecarlo - 1976-1977 2 bearings required per car

Non Magnetic Oil Drain Plug

Non-magnetic oil drain plugFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 (Transmission only) Requires a 12mm allen wrench - our part number LU0-001 Also fits transmission and...

Magnetic Oil Drain Plug

Magnetic oil drain plugFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 (Transmission only) Requires a 17mm wrench Also fits transmissions and differentials Does not fit the new...

Speedometer Drive Seal

Speedometer drive sealFIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985 FIAT 124 Sport Coupe - 1967-1975FIAT and Bertone X1/9 - 1974-1988 This seal is located in the speedometer drive where the cable attaches

Transmission Gasket Set - 1974-78

Transmission gasket set - 4-Speed FIAT X1/9 - 1974-1978   Fits four-speed transmissions Supplied with input shaft seal No axle shaft seals    

Transmission Gasket Set - 1974-88

Transmission gasket set FIAT and Bertone X1/9 - 1974-1988   Fits both four and five-speed transmissions Supplied with input shaft and shifter seals No axle shaft seals    

Transmission Gasket Set with Seals - 1979-88

Transmission gasket set with seals FIAT and Bertone X1/9 - 1979-1988   Supplied with all seals - unlike some others    

Lower Transaxle Mount

Lower transmission or transaxle mountFIAT X1/9 - 1975-1980   Intended for 1975-80 models but can be used on later X1/9s and Bertone - For later models there is no provision for attachement of the exhaust system

Shift Rod at Body Boot

Shifter rod to body bootFIAT and Bertone X1/9 - 1974-1988

Transmission Synchronizer Ring - 5th Gear

5th gear transmission synchronizer ring FIAT 124 Spider, Spider 2000 and Pininfarina - 1966-1985FIAT 124 Sport Coupe - 1967-1975FIAT X1/9 - 1974-1977 - 3rd and 4th gears only FIAT & Bertone X1/9 - 1979-1988    

FIAT 131/Brava Transmission Gasket Set

  Garage sale items are parts that we have limited and non-replenishable quantities, scratch items, or New Old Stock Items.  Items are new unless otherwise stated.  There are no returns on Garage Sale items.   FIAT 131 Transmission...

X 1/9 Reverse Light Switch

Reverse light switchFIAT and Bertone X1/9 - 1974-1988  

X1/9 Left Stub Axle Seal

Left side stub axle seal FIAT X1/9 and Bertone - 1979-1988     For five speed transmissions

X1/9 Right Stub Axle Seal

Right side stub axle seal FIAT X1/9 and Bertone - 1979-1988   For five speed transmissions

X1/9 Shifter Seal

Transmission shifter seal FIAT X1/9 and Bertone - 1974-1988   Located where the shift rod enters the transmission  

Shifter Flexible Linkage

Transmission shifter flexible linkage - sometimes call "lollypop" FIAT X1/9 and Bertone - 1974-1988 (except 1979-1980 carbureted)    

Input Shaft Seal

Input shaft seal FIAT X1/9 and Bertone - 1974-1988 Transmission input shaft seal      

Shift Linkage Bolt Nut & Bushing Kit

Transmission shifter linkage kit - bolt, nut and bushing FIAT X1/9 and Bertone - 1974-1988

Cluster shaft - 1979-80

Cluster shaftFIAT X1/9 - 1979 to 11/1980 production date With keyed 5th gear - Toothcount: 12/17/22/47 (not counting the reverse gear) Be sure to check the toothcount against your shaft before ordering

Reverse Idler Gear -1974-84

Transmission reverse idler gear FIAT & Bertone X1/9 - 1974-1984 to VIN #149269 31 teeth 16mm Inside diameter

1/2 Shift Fork - 1978-88

1/2 Shift forkFIAT and Bertone X1/9 - 1978 to 1988  

1st Gear -1984-88

Transmission first gear Bertone X1/9 - From VIN 0145857 (1984) to 1988 45 teeth

1-2-Reverse Synchro Sleeve - 1974-77

1-2-Reverse synchro sleeve FIAT and Bertone X1/9 - 1974-1977 Synchronizer sleeve for first and second gear which also incorporates the reverse gear Please check thickness to ensure this is the correct part - This is approx 24mm thick

1-2 OEM Slider Hub - 1974-88

1-2 slider hubFIAT and Bertone X1/9 - 1974-1988 This is the part that the synchronizer sleeve for first and second gears rides on OEM - Original FIAT part  

1-2 Synchro Ring - 1974-88

1-2 synchro ringFIAT and Bertone X1/9 - 1974-1988 This is the synchronizer ring for first or second gear Need one synchro ring per gear

1-2-Reverse Synchro Sleeve - 1977-88

1-2-Reverse synchro sleeveFIAT and Bertone X1/9 - 1977-1988 This is the synchronizer sleeve for first and second gear which also incorporates the reverse gear Please check thickness to ensure this is the correct part - This is approx 26mm thick

3-4 OEM Slider Hub - 1978-88

3-4 slider hubFIAT and Bertone X1/9 - 1978-1988 This is the part that the synchronizer sleeve for third and forth gears slides on OEM - Original FIAT part  

2nd Gear - 1977-88

Transmission second gear FIAT and Bertone X1/9 - 1977-1988 38 teeth  

3rd Gear - 1978-80

Transmission 3rd gear FIAT and Bertone X1/9 - 1978-1980 32 teeth - Always check tooth count before ordering  

3rd Gear - 1981-84

Transmission third gear FIAT and Bertone X1/9 - from VIN 147744 (1981) to 1984 57 teeth - Always check toothcount before ordering  

3/4 Shift Fork - 1974-88

3/4 Shift forkFIAT and Bertone X1/9 - From VIN 78919 to 1988    

4th Gear -1981-84

Transmission 4th gear FIAT and Bertone X1/9 - 1981-1984 (to VIN 0147744) 61 teeth - Always check tooth count before ordering For five-speed transmissions

4th Gear Bushing - 1977-88

4th Gear BushingFIAT and Bertone X1/9 - 1977-1988  

4th Gear -1979-80

Transmission fourth gear FIAT X1/9 - 1979-1980 49 teeth - Always check toothcount before ordering For five-speed transmissions

4th Gear -1984-88

Transmission fourth gear Bertone X1/9 - From VIN 0147744 (1984) to 1988 49 teeth For five-speed transmissions

4th Gear -1974-78

Transmission fourth gear FIAT X1/9 - From VIN ending in 78918 in 1976 to 1978 47 teeth For four-speed transmissions

5th Gear on Input Shaft - 1980-84

Transmission 5th gear on input shaft - splinedFIAT and Bertone X1/9 - From November of 1980-1984 (to spares number 147744) 51 teeth - Always check tooth count before ordering Splined connection to shaft

5th Gear Shift Fork - 1979-88

5th Gear shift forkFIAT and Bertone X1/9 - 1979 to 1988  

Key for 5th Gear - 1979-80

Key for fifth gear FIAT X1/9 - 1979 to November 1980 production date Use with our sku 9TR615

5th Gear on Input Shaft - 1979-80

Transmission fifth gear on input shaft - keyed attachmentFIAT X1/9 - 1979 to November 1980 production date 51 teeth For the key, use our sku 9TR090

5th Gear on Input Shaft - 1984-88

Transmission fifth gear on input shaft - splinedBertone X1/9 - 1984-1988 (after spares number 147744) 51 teeth - Mates with 9TR613 Splined connection to shaft

5th Gear - 1984-88

Transmission fifth gear on output shaftBertone X1/9 - 1984-1988 (after spares number 147744) 44 teeth

Synchronizer Sleeve - 5th Gear

Synchronizer sleeve 5th gearFIAT 124 Spider, Spider 2000 and Pininfarina - 1968-1985FIAT 124 Sport Coupe 1968-1975FIAT and Bertone X1/9 - 1979-1988

Synchro Ring Dog Kit - 1978-88

Synchro Ring Dog Kit for 3rd and 4th gearsFIAT and Bertone X1/9 - 1978-1988 Need one kit per gear